|
|
| (4 intermediate revisions by the same user not shown) |
| Line 1: |
Line 1: |
| '''Materials:'''
| |
|
| |
|
|
| |
| * Beaglebone Black Industrial
| |
| * Logitech C545 webcam
| |
|
| |
|
| |
| '''Steps:'''
| |
|
| |
| Installed Debian Jessie via a netinstall from [http://elinux.org/BeagleBoardDebian Elinux.org BeagleBoardDebian]. Used serial port. Migrated to Devuan. Installed Zoneminder using jessie-backports according to [http://zoneminder.readthedocs.io/en/stable/installationguide/index.html official install guide].
| |
|
| |
|
| |
| Industrial BBB was chosen, in the hopes of using it as a dashcam under winter conditions.
| |
|
| |
| Camera works plugged into USB. No external power needed. The camera was obtained by looking at the [https://h-node.org/ H-node] hardware compatibility list for webcams. There is no guarantee that all webcams will support the framebuffer grab that ZM requires, but in this case, it did. The webcam is 960x720p and cost about $12.
| |
|
| |
| Logitech camera works under the following settings
| |
|
| |
| '''Zoneminder settings:'''
| |
| * Source: Local
| |
| * Maximum FPS: 3
| |
| * Device Path: /dev/video0
| |
| * Capture Method: Video for Linux 2
| |
| * Device Format: PAL
| |
| * Capture Palette: *MJPEG
| |
| * Capture Width (pixels): 960
| |
| * Capture Height (pixels): 720
| |
|
| |
| Total load with camera, gets about 960x720 3FPS, with .7 load on the server, in monitor mode. Making this a potential external ZM server.
| |
|
| |
| YUYV works with resolution of 320x240, but no higher. MJPG is able to get 320x240, 640x480, and 960x720. I put the wrong resolution in during MJPEG mode, but the ZM logs happily told me that the 'correct' resolution available was 960x720, so I used that, and all worked.
| |
|
| |
| This being an SBC, there is a additional interfaces, expansions (I2C, GPIO) to use in addition to the camera itself. Sensors can be added easily.
| |
|
| |
|
| |
| '''Notes:'''
| |
| * I ran into problems using this BBB with a long (>25 ft) ethernet cable. Network functions were slow, or failing. This could be a problem if you were to use these as substitutes for cameras. It may have been my particular model (BBB Element14 industrial). A shorter cable resolved all issues.
| |
