Difference between revisions of "Escam"

From ZoneMinder Wiki
Jump to navigationJump to search
Line 6: Line 6:
QD300 allows you to configure both a primary and secondary stream. You can set it up in the  "device config->Encode" section of the camera
QD300 allows you to configure both a primary and secondary stream. You can set it up in the  "device config->Encode" section of the camera


In this example, I've enabled the primary stream and disabled the secondary stream. You can enable both. Note that I've set the FPS to 3 as its a good idea to reduce FPS in-camera and not ZoneMinder. Set it to a value that makes sense for you.


[[File:Qd300-settings.png]]
[[File:Qd300-settings.png]]




You have two methods to access the images (see Remote Host Path):
===ZoneMinder settings===
 
* Remote Protocol: HTTP
* Remote Method: Simple
* Remote Host Name: {username}:{password}@{camera ip}
* Remote Host Port: 80
* Remote Host Path: /videostream.cgi? (i need to use /videostream.cgi?resolution=32&rate=0& to get the highest resolution and fps)
* or
* Remote Host Path: /snapshot.cgi?
* Remote Image colors: 24 bit
* Capture Width: 640
* Capture Height: 480
Select the right resolution for the camera, such as 640x480.
To set the resolution for the camera, use a web browser and go to the configuration page of the camera. While in the configuration page, also set the the username and password accordingly.

Revision as of 10:20, 2 November 2015

I've tested QD300 so far. I am told QD900 will be the same

These are the settings for QD300.

In camera settings

QD300 allows you to configure both a primary and secondary stream. You can set it up in the "device config->Encode" section of the camera

In this example, I've enabled the primary stream and disabled the secondary stream. You can enable both. Note that I've set the FPS to 3 as its a good idea to reduce FPS in-camera and not ZoneMinder. Set it to a value that makes sense for you.

Qd300-settings.png


ZoneMinder settings