Difference between revisions of "Foscam FI9821W V2"
| Line 43: | Line 43: | ||
Note 2: You may be able to use just the camera password or user=(user)&pwd=(password) | Note 2: You may be able to use just the camera password or user=(user)&pwd=(password) | ||
Note 2 addendum: I was only able to PTZ working if Control Device was in the format of user:password | |||
You should be able to use higher or lower resolutions but keep the WidthxHeight ratio within the 640x320 value | You should be able to use higher or lower resolutions but keep the WidthxHeight ratio within the 640x320 value | ||
Revision as of 18:23, 15 February 2016
Foscam FI9821W V2 with control
With the newer version of the Foscam firmware you are prompted to change the default login. I did this then added another user called admin. I'm not sure if this is necessary but I was able to get the camera to work with control.
Camera Video Settings:
Stream Type HD Mode
Resolution 720P
Bit Rate 128K
Frame Rate 5
Key Frame Interval 50
Variable bitrate Yes
Zoneminder Monitor Settings:
Source Type Ffmpeg
Function Modect (or your choice)
Source Path rtsp://admin:(Password)@IP-Address:88/videoMain
Remote Method RTP/Unicast
Capture Width 640
Capture Height 320
Control Type Foscam FI9821W (see note 1)
Control Device (Password) (see note 2)
Control Address IP-Address:88
Auto Stop Timeout 1
Note 1: Edit Foscam FI9821W and remove check marks in Zoom, Focus, White, Iris, and change Presets number from 16 to 8
Note 2: You may be able to use just the camera password or user=(user)&pwd=(password) Note 2 addendum: I was only able to PTZ working if Control Device was in the format of user:password
You should be able to use higher or lower resolutions but keep the WidthxHeight ratio within the 640x320 value
