ZMNinja

ZMNinja is a program that allows cellphone and desktop access to ZM. Cellphone access is $5 per mobile device. Desktop access is free. Desktop access can be used to test and verify your ZMNinja setup is working, whereby then you can add a mobile phone with a reasonable expectation it will work.

This is the community wiki documentation on ZMNinja. Please refer to the official docs for more information. https://zmninja.readthedocs.io

Setting up ZMNinja

Typically when setting up ZMNinja you will be doing so for WAN access. This will require the following:

• Confirm API is working (see API)
• Enable SSL for apache (covered briefly in API page above)
• Configure paths for ZMNinja in settings

There isn't much more to it than that. If your API is working, and you have SSL working, then ZMNinja should do its job.

CAVEAT: This assumes you have installed ZM properly. The easiest (and most maintained) guides are Debian, and Ubuntu.

Configure Paths for ZMNinja

They can look something like this (Note that usually it autofills this for you, once you type in the IP):

I personally use ZM Authentication, and low bandwidth mode.

ZM Portal URL: https://WANIPOFSERVER/zm/
path to cgi-bin: https://WANIPOFSERVER/zm/cgi-bin
ZM api url:        https://WANIPOFSERVER/zm/api

The rest is defaults.

Security

It is recommended to have strong passwords for ZMNinja on the WAN. One method to isolate your network from a potentially vulnerable Zoneminder system on the WAN is to have a separate static IP for your camera network, and then have all of your office LAN use ZMNinja out to the WAN and back to view cameras.

See also: [1]

SSL should be the only port accessible via WAN.

Geoblocking is a good idea. There are guides online for geoblocking such as:

• https://wiki.pratznschutz.com/index.php/Apache2_Geo_IP

e.g.

#apt-get install libapache2-mod-geoip 
#a2enmod geoip 

geoip.conf

<IfModule mod_geoip.c>
 GeoIPEnable On
 GeoIPDBFile /usr/share/GeoIP/GeoIP.dat
</IfModule>

Now, edit your /etc/apache2/conf-available/zoneminder.conf to look something like this:

Alias /zm /usr/share/zoneminder/www
<Directory /usr/share/zoneminder/www>
 Options -Indexes +FollowSymLinks
 <IfModule mod_dir.c>
   DirectoryIndex index.php
 </IfModule>
       AllowOverride FileInfo Options
       SetEnvIf GEOIP_COUNTRY_CODE FR AllowCountry
       Deny from all
       Allow from env=AllowCountry
</Directory>

php test script (note: remove html comment tags)

<!--?php $country_name = apache_note("GEOIP_COUNTRY_NAME"); echo "Land: " . $country_name; ?-->

Note that more configuration on zoneminder.conf will be needed, but the above should at least show you that it's working. Beware that existing connections may need to time out if one is open.

Troubleshooting

If you do have trouble, you can refer to the Debug Logs included in ZMNinja.

For further information, refer to the official docs.