Escam

I've tested QD300 so far. I am told QD900 will be the same

These are the settings for QD300.

In camera settings

QD300 allows you to configure both a primary and secondary stream. You can set it up in the "device config->Encode" section of the camera

You have two methods to access the images (see Remote Host Path):

• Remote Protocol: HTTP
• Remote Method: Simple
• Remote Host Name: {username}:{password}@{camera ip}
• Remote Host Port: 80
• Remote Host Path: /videostream.cgi? (i need to use /videostream.cgi?resolution=32&rate=0& to get the highest resolution and fps)
• or
• Remote Host Path: /snapshot.cgi?
• Remote Image colors: 24 bit
• Capture Width: 640
• Capture Height: 480

Select the right resolution for the camera, such as 640x480. To set the resolution for the camera, use a web browser and go to the configuration page of the camera. While in the configuration page, also set the the username and password accordingly.