Cisco

WVC80N

• MPEG-4
  • Source Type: ffmpeg
  • Source Path: http://##.##.##.##/img/video.asf OR http://User:Pass@##.##.##.##/img/video.asf

• MJPEG
  • Remote Protocol: HTTP
  • Remote Method: Simple
  • Remote Host Name: ip.address (or User:pass@ip.address if you configured the cam to only allow authenticated viewing)
  • Remote Host Port: 80 (or whatever port you are forwarding if remote)
  • Remote Host Path: /img/video.mjpeg OR /img/mjpeg.cgi

CIVS-IPC-2611 / 2621V

• MPEG-4
  • Source Type: remote
  • Remote Protocol: RTSP
  • Remote Method: RTP/RTSP
  • Remote Host Name: User:pass@ip.address (I used admin acc)
  • Remote Host Port: 554 (defined at cam web interface)
  • Remote Host Path: /img/video.sav (don't forget to choose MPEG-4 Stream at cam web interface)
  • Resolution depending on NTSC or PAL

CIVS-IPC-6400

Tested on Firmware 2.5.0-10 with H.264.

• Setup
  • Setup->Network Setup->Basic
    • Check boxes Disable Session ID and Enable ONVIF
  • Setup->Feature Setup->Streaming
    • If you want to use at two different resolutions be sure to follow the matrix in the Administration Guide [1]
  • You can turn down Password Complexity under Administration->Password Complexity

• H.264
  • Source Type: Remote
  • Remote Protocol: RTSP
  • Remote Method: RTP/RTSP
  • Remote Host Name: user:pass@ipaddress (I created a viewer-only zoneminder account)
  • Remote Host Port: 554 (defined in Streaming Settings)
  • Remote Host Path:
    • Stream 1: /StreamingSetting?version=1.0&action=getRTSPStream&ChannelID=1&ChannelName=Channel1
    • Stream 2: /StreamingSetting?version=1.0&action=getRTSPStream&ChannelID=3&ChannelName=Channel3
  • Resolution as defined in Streaming Settings

I've had trouble with unexpected exit status for this camera, using FFMPEG seems to be working better.