Difference between revisions of "Escam"
From ZoneMinder Wiki
Jump to navigationJump to search
(Created page with "I've tested QD300 so far. I am told QD900 will be the same ==In camera settings== You have two methods to access the images (see Remote Host Path): * Remote Protocol: HTTP ...") |
|||
| Line 1: | Line 1: | ||
I've tested QD300 so far. I am told QD900 will be the same | I've tested QD300 so far. I am told QD900 will be the same | ||
These are the settings for QD300. | |||
==In camera settings== | ==In camera settings== | ||
QD300 allows you to configure both a primary and secondary stream. You can set it up in the "device config->Encode" section of the camera | |||
[[File:Qd300-settings.png]] | |||
You have two methods to access the images (see Remote Host Path): | You have two methods to access the images (see Remote Host Path): | ||
Revision as of 11:19, 2 November 2015
I've tested QD300 so far. I am told QD900 will be the same
These are the settings for QD300.
In camera settings
QD300 allows you to configure both a primary and secondary stream. You can set it up in the "device config->Encode" section of the camera
You have two methods to access the images (see Remote Host Path):
- Remote Protocol: HTTP
- Remote Method: Simple
- Remote Host Name: {username}:{password}@{camera ip}
- Remote Host Port: 80
- Remote Host Path: /videostream.cgi? (i need to use /videostream.cgi?resolution=32&rate=0& to get the highest resolution and fps)
- or
- Remote Host Path: /snapshot.cgi?
- Remote Image colors: 24 bit
- Capture Width: 640
- Capture Height: 480
Select the right resolution for the camera, such as 640x480. To set the resolution for the camera, use a web browser and go to the configuration page of the camera. While in the configuration page, also set the the username and password accordingly.
