Brickcom

WCB-100a

This camera is 802.11 b/g/n (at least b/g)
It is also wired and the documents indicate is is PPoE

Both mjpeg and mpeg4 work as indicated.
format mjpeg for the cameras using channel 2 as the source is:
http://camera_ip/channel2
Some of them may need the login and password:
http://login:pwd@camera_ip/channel2

Format mpeg4 is as follows, this will be on channel 1
rtsp://camera_ip/channel1
I have not needed to use the login to access this stream.

ZM Source info for mjpeg stream
Tab

+ General
    Name                                test1
    Source Type                         remote
    Function                            Whatever you have set
    Enabled                             []     check it to start capture
    Linked Monitors                     Whatever
    Maximum FPS                         5 (my setting)
    Alarm Maximum FPS                   10 (ditto)
    Reference Image Blend %ge           7 
    Triggers                            none
+ Source
    Remote Protocol                     http	
    Remote Method                       simple
    Remote Host Name                    ip_address OR login:pwd@ip_address
    Remote Host Port                    80   (unless you have set something different)
    Remote Host Path                    channel2 (unless you are using channel1)
    Remote Image Colors                 24 bit
    Capture Width (pixels)              1280
    Capture Height (pixels)             800
    Preserve Aspect Ratio               []
    Orientation                         normal 

ZM Source info for mpeg4 stream
Tab

+ General
    Name                                test1
    Source Type                         remote
    Function                            Whatever you have set
    Enabled                             []     check it to start capture
    Linked Monitors                     Whatever
    Maximum FPS                         5 (my setting)
    Alarm Maximum FPs                   10 (ditto)
    Reference Image Blend %ge           7 
    Triggers                            none
+ Source
    Remote Protocol                     rtsp	
    Remote Method                       rtp/rtsp
    Remote Host Name                    ip_address OR login:pwd@ip_address
    Remote Host Port                    554  (unless you have set something different)
    Remote Host Path                    channel1 (unless you are using channel2)
    Remote Image Colors                 24 bit
    Capture Width (pixels)              1280
    Capture Height (pixels)             800
    Preserve Aspect Ratio               []
    Orientation                         normal 

WCB-100Ap-0c

This camera is 802.11 a/b/g/n (at least a/b/g)
It is also wired and the documents indicate is is PPoE
I have been using it on the a side

Both mjpeg and mpeg4 work as indicated.
format mjpeg for the cameras using channel 2 as the source is:
http://camera_ip/channel2
All I tested needed the login and password:
http://login:pwd@camera_ip/channel2

Format mpeg4 is as follows, this will be on channel 1
rtsp://camera_ip/channel1
I have not needed to use the login to access this stream.