Brickcom

WCB-100a

This camera is 802.11 b/g/n (at least b/g)
It is also wired and the documents indicate is is PPoE

Both mjpeg and mpeg4 work as indicated.
format mjpeg for the cameras using channel 2 as the source is:
http://camera_ip/channel2
Some of them may need the login and password:
http://login:pwd@camera_ip/channel2

Format mpeg4 is as follows, this will be on channel 1
rtsp://camera_ip/channel1
I have not needed to use the login to access this stream.

ZM Source info for mpjpeg stream Tab + General

  Name	                                 test1
  Source Type	                         remote
  Function	                         Whatever you have set
  Enabled	                         check it to start capture
  Linked Monitors 	                 Whatever
  Maximum FPS	                         5 (my setting)
  Alarm Maximum FPS	                 10 (ditto)
  Reference Image Blend %ge	         7 
  Triggers                              none

+ Source

  Remote Protocol                       http	
  Remote Method	                 simple
  Remote Host Name	                 ip_address OR login:pwd@ip_address
  Remote Host Port	                 80   (unless you have set something different)
  Remote Host Path	                 channel2 (unless you are using channel1)
  Remote Image Colors	                 24 bit
  Capture Width (pixels)	         1280
  Capture Height (pixels)	         800
  Preserve Aspect Ratio	         []
  Orientation                           normal 

WCB-100Ap-0c

This camera is 802.11 a/b/g/n (at least a/b/g)
It is also wired and the documents indicate is is PPoE
I have been using it on the a side

Both mjpeg and mpeg4 work as indicated.
format mjpeg for the cameras using channel 2 as the source is:
http://camera_ip/channel2
All I tested needed the login and password:
http://login:pwd@camera_ip/channel2

Format mpeg4 is as follows, this will be on channel 1
rtsp://camera_ip/channel1
I have not needed to use the login to access this stream.